Published in Sydney by: James Glen Pty Ltd ACN 000 472 506 ABN 38 000 472 506 Unit F2, Lidcombe Business Park 3-29 Birnie Avenue Lidcombe NSW 2141 Australia Telephone (02) 9737 5299 Facsimile (02) 9737 0028 This publication is copyright. Other than for the purposes of and subject to the conditions prescribed under the Copyright Act 1968 (as amended), no part of it may in any form or by any means (electronic, mechanical, microcopying, photocopying, recording or otherwise) be reproduced, stored in a retrieval system or transmitted without prior written permission of the copyright owner. Enquiries should be addressed to James Glen Pty Ltd. Unauthorised reproduction in whole or in part is an infringement of copyright. James Glen Pty Ltd will actively pursue any breach of its copyright. Information contained in this training manual has been obtained from AS/NZS Standards, International Standards, data provided by or published by international fastener suppliers, manufacturers and institutions, and by direct calculation and measurement by James Glen Pty Ltd. Every care has been taken by the staff of James Glen Pty Ltd in compilation of the data contained herein and in verification of its accuracy when published, however the content of this training manual is subject to change without notice due to factors outside the control of James Glen Pty Ltd and this manual should, therefore, be used a s a guide only. For example, the products referred to in this publication are continually improved through further research and development and this may lead to information contained in this manual being altered without notice. This training manual is published and distributed on the basis that the publisher is not responsible for the results of any actions taken by users of information contained in this training manual on the basis of information contained in this manual nor for any error in or omission from this manual. James Glen Pty Ltd does not accept any responsibility whatsoever for misrepresentation by any person whatsoever of the information contained in this training manual and expressly disclaims all and any liability and responsibility to any person, whether a reader of this training manual or not, in respect of claims, losses or damage or any other matter, either direct or consequential arising out of or in relation to the use and reliance, wether wholly or partially, upon any information contained or products referred to in this manual.     Click here to download the complete Training Manual. (588kb)   You will need Adobe Acrobat to view this file. Click the logo for a free download